Juniper JN0-280 Dumps

In Junos OS, routing information is stored in different routing tables depending on the protocol and address family. For IPv6 addresses, the routing table used isinet6.0.

Step-by-Step Explanation:

Routing Tables in Junos:

inet.0: This is the primary routing table for IPv4 unicast routes.

inet6.0: This is the primary routing table for IPv6 unicast routes.

inet.3: This routing table is used for MPLS-related routing.

Other routing tables, like inet.1, inet.2, are used for multicast and other specific purposes.

inet6.0 Routing Table:When IPv6 is enabled on a Juniper router, all the IPv6 routes are stored in theinet6.0table. This includes both direct routes (connected networks) and learned routes (from dynamic routing protocols like OSPFv3, BGP, etc.).

Verification:To view IPv6 routes, the command show route table inet6.0 is used. This will display the contents of the IPv6 routing table, showing the network prefixes, next-hop addresses, and protocol information for each route.

Juniper Reference:

Junos Command: Use show route table inet6.0 to check IPv6 routing entries.

IPv6 Routing: Ensure that the IPv6 protocol is enabled on interfaces and that routingprotocols like OSPFv3 or BGP are properly configured for IPv6 traffic handling.

In athree-stage IP fabric(also known as a Clos fabric), traffic between any two points (ingress to egress) in the fabric isonly two hops away.

Step-by-Step Breakdown:

Three-Stage IP Fabric:

Leaf Layer: Leaf switches connect directly to servers and edge devices.

Spine Layer: Spine switches provide connectivity between leaf switches but do not connect to each other directly.

Two-Hop Communication:In this architecture, every leaf switch is connected to every spine switch. Therefore, when a packet enters the fabric via an ingress leaf switch, it is forwarded to a spine switch, which then directs the packet to the correct egress leaf switch. This path always involves exactly two hops:

Ingress leaf → Spine → Egress leaf.

Benefits:This consistent two-hop path ensures predictable latency and makes the network highly scalable while maintaining low complexity.

Juniper Reference:

IP Fabric Architecture: This two-hop property of Clos fabrics is a hallmark of spine-leaf designs, as supported by Juniper's QFX and EX switches in data centers.

The exhibit shows a BGP peering scenario between three routers:router1androuter2are part of the same AS (AS65000), while theSP routeris in a different AS (AS65101). This indicates anEBGP (External BGP)peering between the SP router and router1, andIBGPbetween router1 androuter2.

Step-by-Step Breakdown:

Next-Hop Behavior in BGP:

IBGP: In IBGP, thenext-hop addressis not modified when advertising routes within the same AS. Thus, when router1 advertises routes learned from router2 to the SP router, it will keep thenext-hop addressof router1, not router2.

EBGP: In EBGP, thenext-hop addressis modified. When router1 receives routes from the SP router, it will advertise them to router2 with thenext-hop addressof router1.

Route Propagation:

Routes received byrouter1fromrouter2will be advertised to the SP router with router1 as the next hop.

Similarly, routes advertised by theSP routerwill be passed on to router2, with router1 remaining as the next hop.

Juniper Reference:

BGP Next-Hop: Juniper's BGP implementations follow standard BGP next-hop behavior, where the next-hop is modified in EBGP but not in IBGP, ensuring proper route advertisement across autonomous systems.