Nutanix NCP-MCI-6.5 Dumps

The correct answer is C. Network latency.

The diagram shows a solution that uses synchronous replication between two remote protection domains, cluster site A and cluster site B. Synchronous replication is a feature that allows near-zero RPO (recovery point objective) by replicating data to the remote site before acknowledging writes to the local site. However, synchronous replication has some requirements and limitations that must be met for it to work properly. One of these requirements is that the network latency between the two sites must be less than or equal to 5 ms1. If the network latency is higher than 5 ms, the synchronous replication will fail and the protection policy will be suspended2.

Therefore, based on the diagram, the most likely cause of the issue is that the network latency between cluster site A and cluster site B is higher than 5 ms, which prevents the synchronous replication from working. To verify this, the administrator can use the “ncli cluster ping” command to measure the network latency between the two sites3. If the network latency is indeed higher than 5 ms, the administrator can either improve the network performance or switch to a different replication mode, such as near-synchronous or asynchronous.

The correct answer is C. The VLAN was not created on the upstream switches.

A VLAN (virtual local area network) is a logical segmentation of a physical network that allows devices on the same VLAN to communicate with each other, regardless of their physical location. A VLAN also isolates the devices on different VLANs from each other, unless there is a router or a layer 3 switch that can route traffic between VLANs. To create a VLAN, the administrator needs to configure the network devices that are involved in the VLAN, such as switches, routers, and hosts. The administrator also needs to assign a unique VLAN ID to each VLAN, which is a number between 1 and 4094 that identifies the VLAN1.

In Nutanix AHV, the administrator can create a Nutanix managed network with a specific VLAN ID for guest VMs. This network can be assigned to VM NICs using Prism Element or Prism Central. However, creating a Nutanix managed network does not automatically create the VLAN on the upstream switches that connect the AHV hosts. The administrator needs to manually configure the upstream switches to allow the VLAN traffic on the ports that connect to the AHV hosts. The administrator also needs to ensure that the upstream switches are interconnected physically or virtually and can forward traffic between different VLANs if needed2.

Therefore, if an administrator has created a Nutanix managed network with a VLAN ID of 512 and notices that the VMs on that network can only communicate with other VMs on the same host, but not with VMs on different hosts in the cluster, the most likely cause of this issue is that the VLAN was not created on the upstream switches. This means that the switches are dropping or blocking the traffic with VLAN ID 512 and preventing it from reaching other hosts or VMs. To resolve this issue, the administrator should create the VLAN on the upstream switches and allow it on the ports that connect to the AHV hosts3.

Automated live migration is a feature of Nutanix that allows the cluster to automatically move VMs from one host to another without any downtime, in order to optimize the performance and availability of the cluster. According to the Nutanix documentation1, automated live migration can occur in the following scenarios:

• Cluster resource hotspot: When a host or a group of hosts experience high resource utilization, such as CPU, memory, or network, the cluster can automatically migrate some VMs to other hosts with lower utilization, in order to balance the load and avoid performance degradation.
• AOS upgrade: When upgrading the Nutanix software (AOS), the cluster can automatically migrate the VMs from the host that is being upgraded to another host in the same availability zone, in order to maintain the VM availability and minimize the impact of the upgrade process.
• AHV host maintenance mode: When putting an AHV host into maintenance mode, the cluster can automatically migrate all the VMs from that host to another host in the same availability zone, in order to prepare the host for maintenance operations such as hardware replacement or firmware update.