VMware 2V0-41.23 Dumps

To allow syslog on an ESXi transport node, the administrator needs to use the esxcli utility to enable the syslog ruleset in the ESXi firewall. The correct syntax for this command is esxcli network firewall ruleset set -r syslog -e true, where -r specifies the ruleset name and -e specifies whether to enable or disable it. The other options are incorrect because they either use an invalid syntax, such as omitting the ruleset name or using -a instead of -r, or they disable the syslog ruleset instead of enabling it, which is the opposite of what the question asks. References: [ESXi Firewall Command-Line Interface], [Configure Syslog on ESXi Hosts]

According to the VMware NSX Documentation, these are the prerequisites for adding nodes to an NSX Management Cluster using the NSX UI:

• All nodes must be in the same subnet and have IP connectivity with each other.
• A compute manager must be configured and associated with the NSX Manager node.
• The NSX Manager node must have a valid license.
• The NSX Manager node must have a valid certificate.

An overlay segment is a logical construct that provides Layer 2 connectivity between virtual machines that are attached to it. An overlay segment can span multiple hosts and can be extended across different subnets or locations using Geneve encapsulation3. Therefore, two virtual machines on the same overlay segment belong to the same Layer 2 broadcast domain, which means they can communicate with each other using their MAC addresses without requiring any routing. The other options are incorrect because they involve Layer 3 or higher network boundaries, which require routing or tunneling to connect different segments. References: VMware NSX Documentation